White Mountain Classic CIDV-30-20, Инструкция по установке и руководство пользователя

Страница: 37 / 40

Page 37 15628-0-0903
PARTS LIST
Index Part
No. No. Description
1 R-1454 Brass Bushing (4 Required)
2 R-1499 Rubber Grommet (4 Required)
3 CI-002 Blower Housing
4 R-1517 Tinnerman Clip (4 Required)
5 R-2804-A Blower Assembly
6 CI-003 Blower Housing Cover
7 R-2099 Cord Set
8 R-3767-A Wire Harness
9A CI-004 Fan Control Bracket
(Use with CIBV-30 and CIVF-25)
9B CI-325 Fan Control Bracket
(Use with CIDV-30)
10 R-2503 Fan Control
11 R-2805 Auto/Off/On Switch
12 CI-220 Fan Control Shield
(Use with CIVF-25)
13 R-1410 Bushing 7/8" Diameter
Cleaning
The blower wheel will collect lint and could require cleaning
once a year. If the air output decreases or the noise level
increases, it indicates a dirty wheel.
Blower Motor
The blower motor does not have oiling holes. Do not attempt
to oil blower motor.
Wiring
The appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70 or
Canadian Electrical Code, CSA C22.1, if an external electrical
source is utilized. This appliance is equipped with a three-
prong [grounding] plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug. For an ungrounded
receptacle, an adapter, which has two prongs and a wire for
grounding, can be purchased, plugged into the ungrounded
receptacle and its wire connected to the receptacle mounting
screws. With this wire completing the ground, the appliance
cord plug can be plugged into the adapter and be electrically
grounded.
CAUTION: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
WARNING:
Unplugging of blower accessory will not stop the
heater from cycling. To shut heater off: Turn
temperature dial or thermostat to lowest setting.
Turn knob on gas control to "OFF", depressing
slightly. Do not force.