OPERATION
A full load will typically take 150 minutes and will use approximately 4.76kWh of electricity.
A half load will typically take 90 minutes and will use approximately 2.55kWh of electricity.
The power consumption of the off-mode is 0.0W and the left-on mode is 0.36W.
1.
Open the door.
2.
Load clothes loosely into the drum. Load sheets first, starting with one corner.
3.
Close the door.
4.
Dry your hands.
5.
Turn the programme selector knob to the desired drying programme.
6.
Select any other features that you require (e.g. Low Heat or Delay Start)
7.
After the Start/Pause button is pressed, the dryer will start the drying cycle. If delay start
was selected, the drying cycle will be automatically performed when the delay time is
over.
8.
If you want to cancel the delay time selected, turn the programme selector to the ‘Off’
position.
9.
If you push the Start/Pause button during the drying cycle, the dryer will stop.
PROBLEM SOLVING
Fault
Indication
Fault
Solution
Bottle Full
Indicator
flashing or on
The bottle is full or the
drying program has
finished.
Remove the bottle and empty out the water. If the
drying programme has stopped mid cycle then
press the Start/Pause button to continue the
drying cycle.
Filter Indicator
on
The air flow is
restricted by a build up
of fluff or the drying
cycle has finished.
Remove and clean both the filter in the door and
in the door opening. Remove any fluff from
inside the filter housings.
Display shows
‘doP’
The door is open or not
closed properly.
or
The heat exchanger is
not fitted or has not
been fitted properly.
Ensure the door is fully closed. A ‘click’ should
be heard from the door latch when the door is
shut properly.
Ensure that the heat exchanger is located properly
in the housing and that the locking levers are in
the locked position.
Display shows
‘ErS’
A program selection
error has occurred.
The display will show ‘ErS’ if a function button
has been pressed that is incompatible with the
selected programme. The error code will also be
displayed if the programme selector is turned
during a drying cycle.
