INTRODUCTION
EN / W-SC3 Mobile / January 2011
5
engineer is covered, but is limited to a reasonable number
of hours and reasonable rates in relation to the actual
repair work that has to be done.
Travel expenses and travel hours are not covered. Also
not covered is the labour required to take a generator out
of a vehicle or for reinstallation. There is no cover for
labour needed to get access to the generator, for example
to remove equipment or parts of the vehicle body etc.
Goods to be delivered under warrantee will be invoiced.
Only after the faulty goods are returned will the invoice be
credited. Payment in advance may be required or
guaranteed by credit card. If after the faulty goods are
returned, it is indicated that the failure was not covered by
warranty a credit will not be issued. For example if a
Printed Circuit Board is returned with clear damage
caused by water, warranty will be refused.
Freight costs to deliver spares by normal mail or carriers is
covered under warranty. Special services like express
mail, overnight delivery etc. are not covered. Taxes and
duties are not covered. For shipments to remote off shore
areas any additional costs incurred over normal carriage
will be invoiced to the customer.
The cost for returning faulty goods is not covered under
warranty.
Additional agreements could be part of the contract of
delivery.
If any problem arises which could be subject of guarantee,
procedures should be followed as described in the
guarantee certificate, unauthorised repairs could lead to
further damage and violate the guarantee conditions.
Should work take place, which is not in
accordance with the guidelines, instructions
and specifications contained in this user’s
manual and the supplementary installation
manual, then damage may occur and the
generating set may not fulfil its specifications.
In all these cases the guarantee may become
invalid. Use original spares only!
1.4 LIABILITY
Whisper Power does not accept responsibility for damage,
injuries or casualties which are the result of operation of
the generating set in specific conditions which brings
dangers which could not be foreseen, or could be avoided
by additional measures. Whisper Power does not accept
liability for damage due to use of the generator, possible
errors in the manuals and the results thereof.
Automatic start/stop
Whisper Power cannot be held responsible for
damage caused by the unattended running generator
using the auto-start/stop mode or interval mode.
1.5 IDENTIFICATION
1.5.1 General
Before using this generating set it is very important to
identify the set correctly. To communicate for service or
ordering parts it is also essential to correctly identify the
generating set. Also for the daily operation of the genera-
ting set it is necessary that the operator knows the correct
specifications.
1.5.2 Nameplate
All required identification data are on the nameplate.
1 The identity of the generating set is given by the
SERIAL NUMBER.
When this number is available the manufacturer can
trace the specifications of the generating set. On the
nameplate are also some basic features of the set:
2 POWER
The nameplate gives the nominal maximum load in
kVA (= kW) calculated with power factor one. When
calculating a load one should always take into
account the power factor or cos phi of this load. The
power should never exceed the nominal power in kW
as shown on the nameplate. Power is rated at an
ambient temperature of 25°C. For higher
Model W-SC3
Article number
40900620
Serial number
Max. power
3 KVA cos phi =0,8
2.5 KVA cos phi = 1
Voltage
230V ± 5%
Frequency 50
Hz
Current 11A
Phase Single
phase
Dimensions
L x W x H
505x400x500mm
Weight 97
kg
Fig 1: Nameplate
