INSTALLATION
6
November 2011 / W-BD3.5/W-BD5 BeltPower / EN
Remote control cable
When an optional remote control panel is in the delivery a
5
m connection
cable will be included. A 10 m and a 15 m
cable are available on request.
Output cable
The output cable is not included, but it can be any cable of
appropriate rating and length to accommodate the
application. Refer to 2.7
2.5
LOW VOLTAGE DC CONTROL SYSTEM
The electrical control system for the W-BD 3.5 is standard
12 to 24 Volt DC and self ranging. The electrical control
system for the W-BD 5 is standard only 12V. When needed
a small12V to 24V converter can be supplied. This power is
taken from the cars/boats starting battery. When operating
there is no significant power consumption. When the unit is
off there will be no consumption at all.
A DC 2 wire supply cable 2 x 2.5mm2 has to be connected
to the vehicle (boat) starter key and should be fused W-BD
3,5 with a
10 Amps fuse
and the
W-BD 5
15 Amps fuse.
This current is only drawn when the engine is starting up.
An additional switch could be applied. Refer to figure 1 and
to 2.4-3 figure 8.
2.6
CONTROL
A local control panel is on the inverter box. A remote control
is optional. A 5 m intermediate 8 pole communication cable
comes with the remote control.
(refer to figure 3).
The control (both on the case and the remote) has an on/off
switch, a scroll button, 4 LEDs that will signals an alarm if
something is wrong (only on the inverter box) and a display
showing specific information on the status of the system,
warnings and alarms. Refer to the users manual for a full
overview of all signals and displays for operation and for
fault finding.
One can mount the remote control on any flat surface and
guide the cable in all directions by opening the pre-shaped
ports in the sides of the plastic case or drill a hole in the
dashboard. For the dimensions see page 15.
2.7
AC POWER SYSTEM (230 VOLT)
The output of the inverter box is 230V AC 50 Hz.
ATTENTION!
Before working (installation) on the system
read the section safety instructions
The electric power supplied by the generator is
of a high voltage and dangerous to people.
Before working (installation) on the system
read the sections on safety in the users
manual.
Be aweare hat people are not used to have
230V available on a vehicle. Put warning signs
on wall sockets and on junction boxes. Instruct
non-regular users of the vehicle. Warn
Figure 4: control panel on inverter box
Figure 3: Remote control cable
Figure 5: remote control panel
