Whirlpool WRT348FMEW, Инструкция пользователя

Страница: 6 / 36

6
5. Check for leaks. Tighten any connections (including
connections at the valve) or nuts that leak.
6. The ice maker is equipped with a built-in water strainer. If your
water conditions require a second water strainer, install it in
the
¹⁄₄
" (6.35 mm) water line at either tube connection. Obtain
a water strainer from your nearest appliance dealer.
Complete the Installation
1. Plug into a grounded 3 prong outlet.
NOTE:
Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to completely
fill ice container.
Refrigerator Doors
Depending on the width of your doorway, you may need to
remove the doors to move the refrigerator into your home. Also,
the door hinges are factory installed on the right-hand side. If you
want the door to open from the other direction, you must reverse
the door swing.
IMPORTANT:
Before you begin, turn the refrigerator control OFF. Unplug
refrigerator or disconnect power. Remove food and adjustable
door or utility bins from doors.
If you are only removing and replacing the doors, see the
“Remove Doors and Hinges” and “Replace Doors and
Hinges” sections.
All graphics referenced in the following instructions are
included later in this section after “Final Steps.”
Tools Needed:
⁵⁄₁₆
" Hex-head socket wrench,
⁵⁄₁₆
" Open-end
wrench,#2 Phillips screwdriver, Flat 2" putty knife, Flat-blade
screwdriver
Remove Doors and Hinges
⁵⁄₁₆
" Hex-Head Hinge Screw
1.
Unplug refrigerator or disconnect power.
2. Using a hex-head socket wrench, remove the three
⁵⁄₁₆
"
hex-head hinge screws from the top hinge and lift up to
remove the hinge.
NOTE: Provide additional support for the doors while the
hinges are being moved. Do not depend on the door magnets
to hold the doors in place while you are working.
3. Lift the freezer door off of the center hinge and set it aside.
4. Remove the washer from the top of the Center Hinge pin.
5. Using a hex-head socket wrench and an open-end wrench,
remove the three screws from the center hinge and remove
the hinge. Set aside.
6. Remove the washer from the bottom of the Center Hinge pin.
7. Lift the refrigerator door from the Bottom Hinge, and set aside.
A. Tube clamp
B. Tube clamp screw
C. Copper tubing
D. Compression nut
E. Valve inlet
A
C
B
D
E
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A.
⁵⁄₁₆
" Hex-head hinge screws B. Top hinge pin
A. Washer
A. Center hinge
B.
⁵⁄₁₆
" Hex-head hinge screws
A
B
A
A
B