7
AIR PURIFIER CARE
-----------------=-
Cleaning
Filter Locations
A. Rear grille
C
.
Pre-filter
B. Release tab
D. HEPA filters
1.
Press POWER to turn off the air purifier.
2.
Unplug air purifier or disconnect power.
3. Press the release tab on the
rear
of the
air purifier.
Gently
pull the rear grille
away from the
unit
and remove.
4.
Remove both HEPA filters
and
the pre-
filter and
set
aside. Do not try to wash
and reuse either the HEPA filters or the
pre-filter.
5. Clean the air purifier with a soft, damp
cloth.
6.
Gently wash the rear grille in soapy
water.
NOTE:
The grille
is
not dishwasher safe.
7.
Insert the 2 HEPA filters
into
the air
purifier. Insert the pre-filter under
the
tabs on the rear grille. See the
"
Filter
Replacement" section.
8.
Place the tabs on the bottom of the rear
grille into the slots in the air purifier.
Gently
close the grille until the grille
locks into place.
9. Plug in
air
purifier or reconnect power.
10.
Press POWER to turn on the air purifier.
Fil
tc1 JP
lrtceN
e 1
NOTE:
The pre-filter and HEPA filter LEDs
will c::hange
to
red when it is time to replace
the filters. For the most efficient operation of
the air purifier, under normal conditions it is
recommended that
yo
u
replace the pre-filter
every 3
months
and the HEPA filter every
year. See "Replacement
Filters"
in
the
"Ass
istance
or Service" section.
1.
Press POWER to turn off the air purifier.
2.
Unplug
air purifier or disconnect power.
3.
Press the
release tab on the rear of the
air purifier. Gently pull
the
rear grille
away
from
the unit and
remove.
4.
Remove and replace
the
indicated filter.
Install
the
new HEPA filters in the same
direction shown by the arrow located on
the
filter frame. Install the new pre-filter
by placing it
under
the tabs on the rear
grille.See the "Filter Locations"
illustration.
NOTE:
Do
not try to wash and reuse
either
the
HEPA filters
or
the pre-filter.
5. Place the tabs on the bottom of the rear
grille
into
the
s
lots
in the air purifier.
Gently close the grille until the grille
locks into place.
6. Plug in air purifier or reconnect power.
7.
Press POWER to turn on the air purifier.
8. To reset the HEPA filter status, press the
HEPA
Filter
Reset button and hold for
5
seconds.
The HEPA filter timer will
reset.
9.
To reset the pre
-
filter
status,
press the
Pre-Filter Reset button and hold for
5 seconds. The pre-filter timer will reset.
NOTES:
• Pressing the filter reset buttons
before either filter
LED
changes to
red will not reset the filter timer.
• Use of
a
non-Whirlpool filter or
failure to replace
the filter
regularly
will invalidate this warranty.
