Whirlpool WEG750H0HB, Руководство по установке

Страница: 23 / 72

23
Adjust Oven Bake Burner Flame (If Needed)
1.
Remove the premium storage drawer, warming drawer or
baking drawer (see the “Remove/Replace Drawer” section).
2.
Locate gas pressure regulator at rear of the drawer
compartment.
NOTE: On models with a warming drawer or baking drawer,
an access cover must be removed to access the gas
pressure regulator.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
3.
Check the oven bake burner for proper flame.
a. Remove the oven racks.
b. To remove the oven bottom: Remove two screws at the
rear of the oven bottom. Lift the rear of the oven bottom
up and back until the front of the panel is away from the
front frame. Remove from oven and place on a covered
surface.
A. Screws
B. Oven bottom
c. Press BAKE.
d. Press the Start pad.
The oven bake burner should light within 8 seconds.
If unsuccessful, the oven bake burner will pause for
40 seconds then retry to light for another 8 seconds.
It will try for three entire cycles.
Electronic igniters are used to light the bake and broil
burners.
This flame should have a 1/2" (13 mm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should
be clean and soft in character. No yellow tips, blowing or
lifting of flame should occur.
4.
If the oven bake flame needs to be adjusted, locate the air
shutter near the center rear of the drawer cavity behind the
access panel. Loosen the locking screw and rotate the air
shutter until the proper flame appears. Tighten locking screw.
A. Locking screw
B. Air shutter
5. Push the Off pad when finished.
6. Reinstall the oven bottom and the premium storage drawer,
warming drawer or baking drawer (see the “Remove/Replace
Drawer” section).
Adjust Oven Broil Burner Flame (If Needed)
Press BROIL, and then press the start pad. Look through the
oven window to check broil burner for proper flame. This flame
should have a 1/2" (13 mm) long inner cone of bluish-green, with
an outer mantle of dark blue, and should be clean and soft in
character. No yellow tips, blowing or lifting of flame should be
present.
If Flame Needs to be Adjusted:
1.
Press the Off pad. Let the oven cool.
2. Loosen the lock screw on the air shutter located at the rear
of the broil burner.
3. Adjust the air shutter as needed.
4.
Tighten lock screw.
A. Lock screw
B. Air shutter
5. Close the oven door. Press BROIL, and then press the Start
pad. Look through the oven window to check broil burner for
proper flame. If flame needs to be adjusted, repeat steps
1 to 5.
A
B
A
B
A
A
B