2
6. Remove screws from dryer door
Remove the 10 screws from the dryer door and set screws off to
the side.
10. Remove door hinges and trim screws
Remove the door hinges and set off to the side. Remove the 3
screws down the left and right sides of the door to remove the
outer trim pieces.
7. Remove inner door
Remove the inner door by using a plastic putty knife to separate
the sides and bottom of the dryer door and trim. There are 2 snaps
on left, right, and bottom of door. Insert the putty knife next to the
snaps.
11. Rotate trim pieces
Lift door up and rotate trim pieces to the opposite side from which
they were removed. Then screw trim pieces back in.
8. Pull door from frame
When you have the door separated from the frame, use a putty
knife to lift up in the center tab and then pull door toward you and
out.
12. Add hinges
Add the hinges to the right side of the door and then flip the hinge
labeled 1 to the bottom of the right side and the hinge labeled 2 to
the top of the right side of the door.
9. Transfer door strike
Remove door strike by pinching the clips from the inside of the
door panel. Then rotate 90° and push out the front. Insert door
strike on the other side of dryer door by pushing in and then add
the door strike plug.
13. Add inside panel
Add inside door panel back into the dryer door by sliding the top
into the top trim piece and then lower door down. Then press
down on the corners to snap into place with the hinges lined up
with the hinge holes.
