TECH SHEET - DO NOT DISCARD
PAGE 3
FOR SERVICE TECHNICIAN’S USE ONLY
PART NO. 9762973 REV. A
DISPLAY
CODES
LIKELY FAILURE
CONDITION
SUGGESTED CORRECTIVE ACTION PROCEDURE
F5
E0
Door and switches
do not agree
1. Unplug range or disconnect power.
2. Check wires and connectors from control to door switch, then from door switch to control.
3. If no damage to wires or connectors, replace door switch.
4. Replace all parts and panels before operating.
5. Plug in range or reconnect power.
6. Press Cancel/OFF key. Program and start the CLEAN mode, and observe for 1 minute to ensure that
operation is normal.
7. Go to step 1 and complete checks.
E1
Door latch not
operating
1. Verify failure, if not displayed. Go to Diagnostics screen 5 (A-Last Fault Code/ B-Cleared Error Code), page 4;and clear the
error code by pressing the START key.
2. Go to Diagnostics mode. Press AUTO CLEAN key to cycle from locked to unlocked states.
A. If the door is not latched (locked) and the DOOR LOCKED icon is lighted go to step A1.
1. Unplug range or disconnect power.
2. Check integrity of latch mechanism from cam/eccentric, through actuating rod, to latch pawl and door slot.
3. Ensure that pawl aligns with the door slot. Correct any mechanical malfunction and go to step 3.
B. If the door is latched (locked) and the DOOR LOCKED icon is not lighted go to step B1.
1. Unplug range or disconnect power.
2. Replace motor assembly and go to step 3.
C. If the door is not latched (locked) and the DOOR LOCKED icon is not lighted go to step C1.
1. Unplug range or disconnect power.
2. Check continuity of the latch motor and the electrical connections between oven control and motor.
- If continuity is present, replace control. Go to step 3.
- If continuity is not present, replace motor assembly. Go to step 3.
3. Replace all parts and panels before operating.
4. Plug in range or reconnect power.
5. Put range into CLEAN mode to verify proper operation.
6. Go to step 1 and complete checks.
E2
Latch error during
CLEAN
1. Unplug range or disconnect power.
2. Check wires and connectors from control to door switch, then from door switch to control.
3. If no damage to wires or connectors, replace door switch.
4. Replace all parts and panels before operating.
5. Plug in range or reconnect power.
6. Press Cancel/OFF key. Program and start the CLEAN mode, and observe for 1 minute to ensure that operation is normal.
7. Go to step 1 and complete checks.
Electrical
Solenoid
Terminals
Broil
(1/8 terminal)
"
Common
(1/4"
terminal)
Bake
(3/16" terminal)
COMPONENT CHECK
Check between each solenoid for 216
Ω
resistance
(Broil terminal to Common, and Bake terminal
to Common).
NOTE:
Always check both solenoids. If one of
the solenoids is defective, neither one will operate.
