Whirlpool R-94, Руководство пользователя

Страница: 21 / 36

3-9
11. Remove the two screws from the front air
guide.
7. Unhook the right side of the front air guide
cover from the front air guide, then lift the
cover out of the guides on both sides, push
the left side out so that it unhooks, and
remove the cover. 10. Remove the screw from the left side of the
rear air guide, and unhook the two tabs
from the condenser slots on the right side.
8. Pull the blower off the front shaft of the fan
motor. NOTE: It may be necessary to
remove the ring clamp if the blower cannot
easily be removed. If so, use a pair of
pliers and squeeze the ring tabs together,
and pull it off the hub.
Unhook
Front Air
Guide
Cover
Lift From
Guide
Front Air
Guide
Pull Out
Blower
Ring Clamp
9. Carefully reposition the evaporator back
inside the front air guide in its normal
mounting position to protect it during the
rest of the procedure (see step 6).
Rear Air Guide
Unhook
Unhook
Screw
Condenser
Front Air
Guide Screws
12. Slide the front air guide assembly toward
the back of the unit until the left and right
side keys clear the slots in the chassis
pan. Lift the air guide assembly, and pull it
forward over the edge of the pan just
enough to allow access to the fan motor
mounting screws.
Front Air
Guide
Assembly
Key
Slide Back
Lift
Chassis Pan
Slot (Each Side)
Continued on the next page