15
Routine Maintenance
WATER SOFTENER CLEANSER
The manufacturer recommends that you use
Whirlpool
®
WHE-WSC Water Softener Cleanser, as
directed, every four months.
Lift the brinewell cover and pour in the entire 16 oz.
bottle of Whirlpool
®
Water Softener Cleanser. Press
the RECHARGE button and hold for three seconds,
until “RECHARGE” begins to flash in the display.
This manual recharge will take about two hours. If
taste, odor, or discoloration are detected in the water,
manually recharge the softener again, then run a cold
water faucet immediately downstream of the softener
until water tastes, smells, and appears normal.
POWER OUTAGE MEMORY
If electrical power to the water softener is lost,
“memory” built into the timer circuitry will keep all
settings for several hours. While the power is out, the
display is blank and the water softener will not
regenerate. When electrical power is restored, the
following will occur:
Reset the present time only if the display is flashing.
The HARDNESS and RECHARGE TIME never
require resetting unless a change is desired. Even if
the clock is incorrect after a long power outage, the
softener operates as it should to keep your water soft.
However, regenerations may occur at the wrong time
of day until you reset the clock to the correct time of
day.
NOTE:
If the water softener was regenerating when
power was lost, it will now finish the cycle.
Содержание LE18
Страница 19: ...19 Notes ...