Whirlpool KitchenAid KHID4 77510, Руководство пользователя

Страница: 11 / 20

11
C B A
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
23
0
V
Wires Number x size
220-240 V ~ +
3 x 4 mm 2
220-240 V 3 ~ + 5 x 1.5 mm 2
380-415 V 3N ~ + 5 x 1.5 mm
2
380-415 V 2N ~ +
4 x 1.5 mm 2
380-415 V 3N ~ 220-240 V ~ 220-240 V ~ (UK and AU)
380-415 V 2N ~ 220-240 V 3 ~
(Belgium only)
380-415 V 2N ~
(NL only)
Connecting to the terminal block
Use an H05RR-F or H05V2V2-F cable for the electrical wiring as indicated in the table below.
Electrical wiring
Important:
- Based on the wiring diagram (see figure), either keep or remove the metal jumpers between the
screws on the terminal block L1-L2 and N1-N2.
- If a wire is provided, see the wiring instructions attached to it.
- Tighten all six screws on the terminal block after connecting the wires.
Examples of jumper fitted (left) or removed (right). See the wiring diagram for details (the jumpers can
be between L1-L2 and between N1-N2).
Connect the yellow/green earth wire to the terminal with the symbol.
This wire must be longer than the other wires.
1. Remove the terminal block cover ( A ) by undoing the screw and inserting the cover in the terminal
block hinge ( B ).
2. Insert the power supply cable into the cable clamp and connect the wires to the terminal block as
shown in the diagram next to it.
3. Secure the power supply cable with the cable clamp.
4. Close the cover ( C ) and screw it on the terminal block using the screw you removed before.
Every time the hob is connected to the mains, it will carry out an automatic check which takes several
seconds.
If the hob already has a power supply cable, follow the instructions accompanying the cable. Connect
the appliance to the mains electricity supply using a multi-pole disconnector with a minimum contact
gap of 3 mm.