Whirlpool KECS100G, Руководство пользователя

Страница: 18 / 42

3-2
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the cooktop, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
REMOVING THE MAINTOP (Coil Models)
Refer to Figure 3-5 for the following steps.
8. Remove the green ground wire screw
from the bottom of the burner box (the
other end is attached to the right hinge).
9. Lift the front of the maintop and unclip the
support rod from the control box.
10. Lift the maintop assembly off the burner
box and pull the conduit out of the burner
box opening, then position the maintop
upside down (as shown in Figure 3-5) on
a covered work surface.
11. If you are replacing the maintop, remove
the screws from the following components,
and reinstall each one on the new maintop
as you remove them:
• Two hinges & ground wire
• Four coil element receptacles
• Indicator light (remove 2 wires from ter-
minals)
• Switch box assembly
1. Turn off the electrical power to the cooktop.
2. Remove the knobs from the control stems.
3. Unsnap the bezels and remove them. To
remove a bezel, pull it toward you and lift
the tabs out of the slots in the maintop (see
Figure 3-2).
7. Remove the two screws from each of the
two hinge covers at the rear of the burner
box (see Figure 3-4).
4. Remove the coil elements and the reflec-
tor bowls.
5. Disconnect the conduit wires from the
junction box wiring.
6. Raise the maintop and position the sup-
port rod against the front of the burner box
(see Figure 3-3).
Hinge Cover
Screws
Figure 3-2
Figure 3-3
Figure 3-4
All manuals and user guides at all-guides.com