Whirlpool HybridCare WHD862CHC, Инструкция по использованию и уходу

Страница: 11 / 56

11
CLEANING THE LINT SCREEN
Clean lint screen after every load
The lint screen is located in the door opening of the dryer.
A screen blocked by lint can increase drying time.
To clean:
1.
Pull the lint screen straight up and out. Press tab down
and open lint screen. Roll lint off the screen with your
fingers.
2.
Push the lint screen firmly back into place.
IMPORTANT:
ʍ
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
As needed cleaning
Laundry detergent and fabric softener residue can build up
on the lint screen. This buildup can cause longer drying times
for your clothes, or cause the dryer to stop before your load is
completely dry. The screen is probably clogged if lint falls off
while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months,
or more frequently, if it becomes clogged due to a residue
buildup.
To wash lint screen:
1.
Roll lint off the screen with
your fingers.
2. Wet both sides of lint screen
with hot water.
3.
Wet a nylon brush with hot water
and liquid detergent. Scrub lint
screen with the brush to remove
residue buildup.
4. Rinse screen with hot water.
5.
Thoroughly dry lint screen with
a clean towel. Reinstall screen
in dryer or lint filter.
CLEANING THE HybridCare™ FILTER AND
FILTER LINT SCREEN
Clean HybridCare™ filter after every 5 loads
The filter is located in bottom corner of dryer. The control
panel has an indicator light to remind you to clean the
HybridCare™ filter.
1. Open the bottom filter door. Lift handle up and pull
out filter. Set filter on the dryer and pull out lint screen
located at the back of the filter. Remove lint off the
screen with your fingers.
NOTE:
If lint still remains on
screen then wet both sides
with hot water. If necessary,
wet a nylon brush with hot
water and liquid detergent.
Scrub lint screen with the
brush to remove residue
buildup. Rinse screen with
hot water.
2. Clean the filter housing
and mesh inside with a
damp cloth, household
vacuum cleaner, or soft
brush. Clean the screen
at the back of the filter
cabinet once a month.
3. Put lint screen back into
filter and put filter back in
dryer cabinet. Dryer will
not operate without filter
and make sure the handle
is downward to lock in
place. LF will display if not
properly seated.
IMPORTANT:
ʍ
Do not run the dryer with the filter loose, damaged,
blocked, or missing. Doing so can cause overheating
and damage to both the dryer and fabrics.