Timer Knob
Timer Screws/
Lockwashers
5.
Remove the two screws and lockwashers
from the timer.
6.
Disconnect the wires from the thermostat
terminals. NOTE: Be sure to reconnect
the wires to the proper thermostat termi-
nals.
To Terminal Block
To Fan Motor
To Timer
To
Terminal
Block
(Ground)
To Fan Motor
To Heater
Thermostat
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
NOTE:
Sharp edges may be present.
1.
Disconnect the power to the drying cabi-
net.
2.
Remove the component panel (see page
4-2 for the procedure).
3.
Remove the two mounting screws and
lockwasher from the shield and remove
the shield from the component panel.
REMOVING THE TIMER
4.
Remove the knob from the timer shaft.
Shield
Screw &
Lockwasher
Screw
4-4
Содержание DryAire LMA1053L
