CAUTION :
The appliance is not intended to be operated by means of an external timer or separate remote controlled
supply system.
-
Do not store explosive or flammable substances such as aerosol cans and do not place or use gasoline or
other flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently
switched on.
INSTALLATION
-
Installation and repairs must be carried out by a qualified technician, in compliance with the manufacturer's
instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically
stated in the user manual.
-
Children should not perform installation operations. Keep children away during installation of the appliance.
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, during and after
the installation of the appliance.
-
Use protective gloves to perform all unpacking and installation operations.
-
After unpacking the appliance, make sure that it has not been damaged during transport. In the event of
problems, contact the dealer or your nearest After-sales Service.
-
After unpacking the appliance, make sure that the appliance door closes properly.
In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any
damage, only remove the oven from its polystyrene foam base at the time of installation.
-
The appliance must be handled and installed by two or more persons.
-
The appliance must be disconnected from the power supply before carrying out any installation operation.
-
During installation, make sure the appliance does not damage the power cable.
-
Only activate the appliance when the installation procedure has been completed.
-
Kitchen units in contact with the appliance must be heat resistant (min 90°C).
-
Carry out all cabinet cutting works before fitting the appliance in the furniture and carefully remove all wood
chips and sawdust.
-
After installation, the bottom of the appliance must no longer be accessible.
-
For correct appliance operation, do not obstruct the minimum gap between the worktop and the upper edge
of the oven.
-
The appliance must not be installed behind a decorative door in order to avoid overheating.
-
The appliance must not be placed on a base.
ELECTRICAL WARNINGS
-
Make sure the voltage specified on the rating plate corresponds to that of your home.
-
The rating plate is on the front edge of the oven (visible when the door is open).
-
For installation to comply with current safety regulations, an omnipolar switch with minimum contact gap of
3mm is required.
-
Regulation require that the appliance is earthed.
-
For appliances with fitted plug, if the plug is not suitable for you socket outlet, contact a qualified technician.
-
Do not use extension leads, multiple sockets or adapters. Do not connect the appliance to a socket which
can be operated by remote control.
-
The power cable must be long enough for connecting the appliance, once fitted in its housing, to the main
power supply.
-
Do not pull the power supply cable.
-
If the power cable is damaged it must be replaced with an identical one. The power cable must only be
replaced by a qualified technician in compliance with the manufacturer instruction and current safety
regulations. Contact an authorized service center.
-
Do not operate this appliance if it has a damaged mains cord or plug, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the mains cord or plug in water. Keep the cord away from hot
surfaces.
-
The electrical components must not be accessible to the user after installation.
-
Do not touch the appliance with any wet part of the body and do not operate it when barefoot.
8
GB
Содержание AXMT 6634/IX
Страница 1: ...AXMT 6634 IX AXMT 6634 WH ...
Страница 43: ...43 ...
