5
How to proceed if ...
...you want to
check the dryer
yourself first:
(If your machine is
not functioning
correctly, please
check the following
points before phoning
for the customer
service – also refer to
relevant chapter in
the instructions for
use)
Drying takes too long /
laundry is not dry enough.
• Has the correct drying programme been
selected?
• Was the inserted laundry too wet
(washing machine spin speed less than
1000 rpm)?
• Is the lint filter dirty
(filter indicator light on)?
• Is the heat exchanger dirty?
(for more information, refer to the
instructions for use)
• Is the room temperature too high?
• Are the “End” “
” and “Anti-crease”
“
” indicator lamps lighting up? The
drying cycle is complete and the laundry
can be taken out.
• If the drying result does not meet your
expectation, select a more dry
programme.
• You can use the dryness adjustment to
optimize the drying results.
• Is the installation/stability correct? (see
chapter “Installation”/“Stability” in the
booklet)
The dryer does not operate
(after a power failure,
always press the “Start
(Pause)” button).
• Is the plug properly inserted into the
mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
• Has the “Start (Pause)” button been
pressed?
• Has the start delay option been selected?
Lint filter, water container
or heat exchanger indicator
lamp on.
• Is the lint filter clean?
• Is the water container empty?
• Has the water container been inserted
correctly?
• Is the heat exchanger clean?
Water droplets underneath
the dryer.
• Has the heat exchanger been inserted
correctly?
• Has any fluff on the heat exchanger seal
been wiped away?
• Has any fluff on the door seal been
wiped away?
• Has the water container been inserted
correctly?
• If used the direct drain connection, is it tight?
Replacing the drum light
bulb (if supplied).
• If the inside lamp does not work, the
bulb may be faulty.
• Unplug the dryer.
• Open the door and unscrew the glass
cover inside the drum.
• Replace the faulty bulb with a new one
and screw the glass cover back on.
• Replacement bulb: Philips 15W, 230/
240V, E14.
All programme sequence
indicators blinking.
• Service call necessary.
