Whirlpool AKT3570/IX, Инструкция по здоровью и безопасности, использованию, уходу и установке

Страница: 5 / 24

B U T H
e f o r e s i n g h e o o d
B U T H
e f o r e s i n g h e o o d
3
I
n s ta l l at i o n
I
n s ta l l at i o n
( ) FIG.1
( ) FIG.3
( ) FIG.2
650-750mm
2. Position
1. Location
• The smoke has to rise up to 25 mm from cook top in order to reach hood's 0
Suggest to close window door before using hood .(FIG. 1)
/
• Air turbulence from window/door may reduce the effectiveness of hood
.
3. Exhaust duct
• 6 diameter exhaust duct is recommended to use in order to maximize
"
suction efficiency
.
• The installation height is measured vertically from center of aluminum
filter of hood to the top of the cook top .
• The min height is 650mm and the max installation height is 750mm for
• Before installing the hood, please apply fast drying glue to the collar and
hood and exhaust duct to the plastic collar and seal with fast drying glue.
securely attach it to the top of cooker hood's vent lid. Install the cooker
After unpacking the appliance, check for any transport damage. Do not install the appliance if it has been damaged.
In the event of problems, contact Whirlpool Customer Service. To prevent any damage, only remove the appliance
from its polystyrene foam packaging at the time of installation.
gas hob.(FIG. 2)
• Avoid left-right or front-dropped inclination.(FIG. 3)
suction efficiency range.
• Packing materials (plastic bags, polystyrene, etc.) must be kept out of children’s reach, as they are potentially
• Make sure the power voltage specified on the appliance’s rating plate is the same as the main voltage.
• Parts supplied
:
b. Duct cover assembly x 1 set
c x x
.
Warranty card 1pc and Instruction manual 1 pc
dangerous.
• Installation must be carried out by a qualified technician.
• Connect the power and switch on the motor and lighting system to check the operation.
a. Detachable oil cup x 1 pc
d. Hardware package x 1 set
(M6 x 1" wooden screw x 4 pcs + washer x 4 pcs + 3/16" x 3/8" flat screw x 2 pcs + M4 x 8 screw x 2 pcs)
e. Duct cover backet x 1pc