Whirlpool AKT3570/IX, Инструкция по здоровью и безопасности, использованию, уходу и установке

Страница: 6 / 24

M M
o u n t i n g e t h o d
M M
o u n t i n g e t h o d
4
1. Mark a line A as shown in below diagram, the distance between the bottom of the hood to the top of cook " "
top is 650-750mm.
2. Draw and mark a center vertical line C on the wall
.
" "
3. Mark hood height line B. (362 mm from line A)
4. Mark mounting screw holes on line B, 132mm apart from the center line(on left and right).
5. Fasten (2) 1 screws into studs on line B but do not tighten all the way. M6 x "
6. Remove the (2) aluminum filters. grease
7. Hang hood nto the mounting screws and hand tighten each screw . i (step 5.) Hook the hood to the wall. Adjust
the hood to make sure that it is level and tighten down partially tightened screws to the body
.
8. Center and attach duct cover mounting bracket to wall just below the ceiling or soffit using (2) x 1 screws , M6 "
+ (2) . washers
9. Install and duct. Seal duct with tape (optional). power cord
10. hood and check for leaks around duct tape. Turn on the air
12. Secure bottom duct cover to hood body by 2 3/16 x 3 8 screws
( ) / .
"
11. Extend inner (top) duct cover upwards and secure to duct cover bracket using (2) M4 x 8 screws.
C
650 750 -
60
362
152
264
A
B
Unit mm ：
Screw holes Screw holes
14. Reinstall filters.
13. Install the oil cup to the center of the motor shell.
Electrical connections must be carried out by a specialized technician,
this appliance must be connected with earth wire.
Supply cord must be disconnected from power source before connection (to
the appliance).
KEEP
ALTKEEP