22
EN
Notes:
Optimum performance levels when using the “Rapid” cycles
can be achieved by respecting the specified number of place
settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories:
for information on comparative EN
testing conditions, please send an email to the following address:
[email protected]
Special wash cycles
and Options
Half Load option/Child lock
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and press the HALF
LOAD button: the indicator light will illuminate.
Press the HALF LOAD button to deselect this option.
Remember to halve the amount of detergent.
Child lock
A long press of HALF LOAD button, will activate the
CHILD LOCK function. The CHILD LOCK function will block the
control panel. To deactivate the CHILD LOCK, long press again.
Sani Rinse option/Tab
This option allows higher temperatures to be used.
Select the washing program, press the SANI RINSE
button and the indicator light will switch on. To deselect the
option, press the same button again.
Ideal to clean crockery and feeding bottles.
Warning:
the crockery and plates could be extremely hot at the
end of the cycle.
The
SANI RINSE option results in lengthening of the wash cycle.
Tablet
option
(Tab)
A long press of Sani rinse button, will activate the TAB
function. This option optimises washing and drying
results. To deactivate the TAB option, long press again.
The TAB option results in a longer wash cycle.
Drain out
To stop and cancel the active cycle, the DRAIN OUT
function can be used.
A long press of START/PAUSE button, will activate the DRAIN
OUT function. The active cycle will be stopped and the water in
the dishwasher will be drained out.
Wash options
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles)
, the
corresponding led/symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Delayed start
The start of the program may be delayed for
a period of time between
0:30
and
24
hours.
1. Select the program and any desired options. Press the
DELAYED START button (repeatedly) to delay the start of
the program. Adjustable from 0:30 to 24 hours.
With each press of the button, the delay start increases by:
0:30 if selection below 4 hours, 1:00 if selection is below
12 hours, 4 hours if selection is above 12 hours. If 24 hours
reached, and the button is pressed, the delayed start is
deactivated.
2. Press the START/PAUSE button: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches
off and the program begins automatically. If at the time of
the countdown the START/PAUSE button is pressed again
the DELAYED START option is cancelled and the selected
program starts automatically.
The Start Delay function cannot be set once a wash cycle
has started.
