Whirlpool 4322525, Руководство пользователя

Страница: 28 / 66

4-8
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
REMOVING A SURFACE ELEMENT &
HOT SURFACE INDICATOR LIGHT ASSEMBLY
1. Turn off the electrical power to the range.
2. Remove the control panel and rotate it
back on top of the maintop so it is out of the
way (see page 4-2 for the removal proce-
dure). NOTE: You do not have to remove
the electronic oven control from the panel.
Refer to Figure 4-7 for the following steps.
3. Remove the four chassis screws (two on
each side) from the control panel chassis.
4. Lift the front of the chassis at the center
and prop it up with a board. NOTE: You
may have to unclip the two cooling fan
motor wires at the left front corner to raise
the chassis high enough to access the
screws.
5. To remove the left front or right rear
element:
a) Remove the screw from the retaining
rod.
b) Disconnect the wires from the termi-
nals of the element and limiter.
6. To remove the left rear or right front
elements,
a) Pull the ends of the rod out from the
brackets.
b) Disconnect the wires from the termi-
nals of the element and limiter.
7. To remove the hot surface indicator
light assembly:
a) Pull down firmly on the indicator as-
sembly body to unfasten the four clips
from the edge of the chassis.
b) Disconnect the leads from the termi-
nals of the limiters.