Whirlpool 400011239758, Инструкция по эксплуатации, Страница: 14 / 36

14
BUILT-IN INSTALLATION
Verify the minimum measurements required for correct instal-
lation of the appliance. The c
off ee machine must be installed in
a column and the column must be firmly fix ed to the wall with
commercially available brackets.
• Kitchen furniture in direct contact with the appliance must
be heat resistant (65°C min).
• To guarantee correct ventilation, leave a gap at the bottom
of the cabinet (see measuremen ts in figur e 1).
• Position the rails on the sides of the cabinet as shown in the
figur e 2. Fix with the screws provided, then extract them
completely.
Position and
fix the lock hook with the four screws provid-
ed, as shown in the figur e placing it in the centre of the
cabinet , flush with the fr ont wall.
If the c off ee machine is installed over a warmer drawer, use
the top surface of this as a reference to position the rails
(fig . 2A).
In this case, there will be no surface to rest the rails on and
the retaining hook must not be installed.
• Fix the power cable with the clip (fig . 3). The power cable
must be long enough to allow the appliance to be extracted
from the cabinet t o fill the coff ee bean container.
The appliance must be earthed in compliance with legis-
lation.
Electrical connections must be performed by a
qualified
electrician following the instructions.
• Position the appliance on the rails, making sure the pins
are correctly inserted in the housings, then fix it with the
screws supplied (fig . 4). If the height of the appliance re-
quires adjusting, use the spacer disks provided.
• If necessary, correct alignment of the appliance by position-
ing the spacers supplied under or at the sides of the support
(fig . 5-6).
• To lift the appliance in the front (max 2 mm), turn the latch
as sho wn in figur e 7.