2
Pro 200 Series
Furnace Operations Manual
Warranty
United States and Canada
Whip Mix Corporation warrants the Pro 200 and Pro Press
200 to the original purchaser against defective workmanship
and materials under normal procedures of installation, use
and service within the dental profession, for a period of
three years or 3750 muffle hours, whichever occurs first.
During which time Whip Mix Corporation will replace, repair
or deny warranty coverage at its discretion. Heat treating
refractory materials, misuse, improper installation, improper
maintenance, accident or abuse will void the warranty. Whip
Mix coverage only applies to Whip Mix supplied parts, and
repairs performed by Whip Mix certified repair technicians.
Repairs performed during the warranty period do not extend
the warranty period. Shipping damage is only covered from
Whip Mix to the intended recipient.
International
Two years parts and labor from date of purchase from dealer.
Recommendations
Note:
During shipping the muffle might absorb moisture
from the air. So, it is recommended you heat the muffle
to dry the moisture before firing any porcelain. To dry the
muffle, set the idle temperature to 400° C (752° F) for one
hour and 600° C (1112° F) for one hour.
Follow the numbered instructions in this section to set the
idle temperature to the temperatures mentioned above.
Whip Mix recommends leaving the furnace on at all times.
Turning the furnace off overnight may cause damage to
the muffle, contamination and void the warranty.
Leaving your furnace on will also extend the life of your
furnace. See Night Mode, page 11 for further information.
Warnings
DO NOT OPERATE THIS FURNACE WITH ANY OTHER
POWER CORD.
DO NOT OPERATE WITH AN EXTENSION CORD.
OPERATING THIS FURNACE ON A CIRCUIT WITH OTHER
FURNACES OR ELECTRICAL APPLIANCES THAT REQUIRE
SIGNIFICANT POWER MAY CAUSE A CIRCUIT BREAKER
TO TRIP.
WHEN OPERATING THE PRO 200, USE ONLY ARGON GAS.
ATTACHING ANY FLAMMABLE OR NOXIOUS GAS IN THIS
FURNACE COULD CAUSE EXPLOSION OR PERSONAL
INJURY!
CAUTION: METAL SURFACE IS HOT DURING OPERATION!
The Pro Series Furnace comes
complete with:
Pro Press 200
Pro 200
Manual
Manual
Cooling Tray
Cooling Tray
Firing Tray
Firing Tray
Press Firing Tray
Power Cord
Power Cord
Temperature Calibration Certificate
Temperature Calibration Certificate
Flash Drive
Ceramic Insert
Quick Start Guide & DVD
Press Air Regulator
Warranty Registration Card
Flash Drive
Tip sheet
Quick Start Guide & DVD
Program Magnet
Warranty Registration Card
Quick Cool Barb and Hose
Tip Sheet
Master Suite DVD
Program Magnet
Quick Cool Barb & Hose
Master Suite DVD
THE TRIANGULAR BLACK AND YELLOW STICKER ON THE
FRONT CENTER OF THE MUFFLE HOOD IS A WARNING
THAT THE METALLIC SURFACE CAN BECOME HOT TO THE
TOUCH. NEVER PLACE YOUR HAND ON THIS SURFACE
OR LEAN ON THE TOP OF THE HOOD WHEN THE UNIT IS
IN OPERATION.
Intended Use:
The Pro 200 furnace is only intended for the firing of
dental porcelain materials or the pneumatic pressing
of molten porcelain materials into lost wax investment
molds. If this furnace is not used in a manner specified by
the Whip Mix Corporation, the protection provided by the
product might be impaired.
IMPORTANT: CONTACT YOUR DEALER OR THE FACTORY
FOR COMPLETE INSTRUCTIONS ON CONVERTING THE
FURNACE BETWEEN 115 VAC AND 220 VAC.
HAZARDOUS LIVE VOLTAGE PRESENT; DISCONNECT AC
MAIN POWER CORD BEFORE REMOVING COVERS.
