23
Pro 200 Series
Furnace Operations Manual
Turn the
Selector Knob
until the desired program is
displayed. If the table has not been lowered, do so now.
Press the
Start Program
button to begin this program.
Continue through this chapter to learn all of the displays
and features available while a program is running.
The Run Program mode allows you to run programs and
to view programs as they are running.
NOTE: YOU MUST BURN THE MOISTURE OUT OF THE
MUFFLE BEFORE FIRING THE FIRST TIME. SEE THE
NOTATION UNDER “CHANGE IDLE TEMPERATURE” ON
PAGE 10.
Running a Program – Repeat Programs
The furnace features a one-button repeat feature. If a
program needs to be repeated, simply press the Selector
Knob and the last program run will be repeated.
Features and Displays Available
While a Program is Running
The following illustration shows the display when a
program is running:
Rotating the Selector Knob while the Program is running
will display additional information in four, successive
screens:
The first alternate screen:
The second alternate screen:
NOTE: IF THE NEXT BUTTON IS PRESSED FROM THIS
SCREEN THE PROGRAM WILL SKIP TO THE NEXT
PROGRAM SEGMENT.
NOTE: THIS FEATURE IS DISABLED IF ANY SPECIAL
FUNCTIONS HAVE BEEN ACCESSED OR IF THE CHANGE
PROGRAM FEATURE HAS BEEN USED AFTER THE LAST
PROGRAM WAS RUN.
The third alternate screen:
Chapter Four — Run Program Menu
NOTE: IF THE SELECTOR KNOB IS PRESSED WHILE THIS
SCREEN IS BEING VIEWED YOU WILL AUTOMATICALLY
FIND YOURSELF IN THE PROGRAM EDIT MODE WITH THE
THE FIRST PARAMETER DISPLAYED BEING THE NEXT
PROGRAM SETTING AFTER THE CURRENTLY RUNNING
SEGMENT. THIS FEATURE ALLOWS YOU TO ALTER THE
PROGRAM WHILE IT IS RUNNING. AFTER THE PROGRAM
FINISHES THIS RUN THE EDITED PARAMETERS WILL
CHANGE BACK TO THE ORIGINALLY STORED VALUES.
THE CHANGES YOU MAKE USING THIS ALTERNATE
SCREEN, DURING A RUNNING PROGRAM WILL NOT BE
PERMANENT.
The fourth alternate screen:
Pressing the Next button will toggle the “No” in the screen
above to “Yes”. Pressing the
Next
button a second time
will change the “Yes” to “No”.
Loading Your Work Into the Furnace
Press the down arrow key to lower the work platform.
Place your work on the firing tray, press the
Start Program
Key
and it will raise automatically under
program control
.
<Prog No. – Prog. Name>
><Current Program Segment>
<Program Time Remaining>
HH:MM:SS
<Current muffle temperature>
<Current Vacuum
Target Temperature:
<XXXX C>
Actual Temperature:
<YYYY C>
Vacuum:
<ZZZ CM>
<Prog No. – Prog. Name>
Time Left:
<HH:MM:SS>
Step Left:
<HH:MM:SS>
NEXT = SKIP STEP
<Prog No. – Prog. Name>
Change This Program?
Press Knob = Continue
<Prog No. – Prog. Name>
Night Mode After?
>No
Next = Option Change
