Page 2
Micro Edge®
Mounting
Bracket
Extension
Flange
Mirror
Bracket
U-Bolt
Fig. 1
Fig. 5
Wiring the Micro Edge:
The Micro Edge harness cable(s) must now be routed to the battery. The path the cables
follow will vary, depending upon where the power supply has been mounted. If the power
supply has been mounted against the rear cab wall, the path would be:
1.
Secure harness cable to Micro Edge mounting bracket with ties (Fig. 4).
2.
Now have the harness cable follow the factory mirror bracket to the point where the
bracket meets the vehicle door. Secure the cable with heavy-duty wire ties.
3.
Remove the interior door panel. When you are sure that no door components will be
damaged, drill a hole in the door just below the point where the factory mirror
bracket connects to the door. Insert a rubber grommet to prevent water leakage.
4.
Insert the harness cable through the hole and route it towards the door’s hinge
panel. Drill a hole in the hinge panel and insert the harness cable.
Be sure the cable
does not interfere with the movement of any door or window components
(Fig. 5).
5.
Route the cable into the cab through the kick panel and then under the rocker panel
molding. Make sure that the
harness cable does not bind up when the door is
opened and closed.
6.
Extend the wires to their destinations as shown in the wiring diagram. Be sure to
use the proper size wires (see wire size warning).
IMPORTANT! The lightbar should be located a
minimum of 16" from any radio antennas!
Mounting the Micro Edge®:
The West Coast mirror mount brackets shown are
purchased separately. Begin the mounting procedure
by loosely assembling the mounting bracket (Fig.1).
Position this partial assembly on the mirror bracket
(Fig. 2). Mount the assembly to the mirror bracket
using the U-Bolt hardware supplied with the brackets
(Fig. 3). Insert the mounting bolt on the Micro Edge
through the hole provided in the extension flange.
Secure as shown in Fig. 3. Adjust the bracket
assembly until the Micro Edge is properly aligned and
tighten the bracket bolts firmly. Repeat procedure for
remaining door.
NOTE:
There is also a mirror mount
bracket available for the 2002 International 7400
Series Navistar® truck not shown here (sSee parts
list).
Fig. 3
Wire
Tie
Fig. 4
Fig. 2
