Page 4
9.
From the engine compartment-side of the fender, reach into the
fender cavity and grasp the cables. Note that this can be challenging
because the area is small.
10. Pull the length of both cables through the cavity and into the engine
compartment. Now pull the cable ends that are secured to the wire
snake out through the wire access hole. The wire snake can now be
removed.
11. Using the waterproof butt connectors (included), connect the 4-
position pigtail to the two cables. Refer to the “Wiring” section for
more information.
12. After the connections are completed, feed the excess cable back
through the wire passage hole until approximately 8” - 10” of cable
remains.
Power
Cable
(to +12VDC)
Communication
Cable
(to H/V Controller)
Power
Cable
(to +12VDC)
Communication
Cable
(to H/V Controller)
13. Locate the rubber mounting gasket and position it onto the fender as
shown.
14. Locate the lower mounting bracket and its support bracket. Install the
supplied rubber grommet into the mounting bracket’s wire passage
hole. Position the support bracket under the mounting bracket as
shown and secure the two brackets together using the hardware
shown.
Lower Mounting Bracket
Support
Bracket
#8-32 x .375”
Philips Pan Head Machine Screw
w/SEMS Washer
