background image

 

MOUNTING OPTIONS: 
 

CAUTION:  

The following figures show the maximum number of field wires (conductors) that can enter the backbox used with 

each mounting option.  If these limits are exceeded, there may be insufficient space in the backbox to accommodate the field wires 
and stresses from the wires could damage the product. 

 

Although the limits shown for each mounting option comply with the National Electrical Code (NEC), Wheelock recommends use of 
the largest backbox option shown and the use of approved stranded field wires, whenever possible, to provide additional wiring room 
for easy installation and minimum stress on the product from wiring. 

 

A

MAXIMUM NUMBER OF CONDUCTORS

AWG #18  AWG #16  AWG #14  AWG #12

8

8

4

8

SURFACE MOUNTING

SIGNAL

4" SQ. X 2-1/8"
DEEP BACKBOX

 SCREWS

(2) #8-32

(2) #10-32 SELF

TAPPING SCREWS

B

MAXIMUM NUMBER OF CONDUCTORS

AWG #18  AWG #16  AWG #14  AWG #12

6

5

4

8

SURFACE INDOOR/OUTDOOR

1/2" CONDUIT

ENTRANCE

WEATHER RESISTANT

BACKBOX TO BE MOUNTED

ON WALL SURFACE

ON TOP

SIGNAL

 SCREWS

(4) #8-32x1" 

SEE APPLICATION NOTE 1.

C

MAXIMUM NUMBER OF CONDUCTORS

AWG #18  AWG #16  AWG #14  AWG #12

8

8

8

8

SURFACE MOUNTING

SIGNAL

4" SQ. X 1-1/2"

EXTENSION

 SCREWS

(2) #8-32

(2) #10-32 SELF

TAPPING SCREWS

4" SQ. X 1-1/2"

DEEP BACKBOX

OR 2-1/8"

RING

 

 

WARNING:  A POSSIBILITY EXISTS THAT THE USE OF MULTIPLE STROBES WITHIN A PERSON'S FIELD OF VIEW, 

UNDER CERTAIN CIRCUMSTANCES, MIGHT INDUCE A PHOTO-SENSITIVE RESPONSE IN PERSONS WITH EPILEPSY.  
STROBE REFLECTIONS IN A GLASS OR MIRRORED SURFACE MIGHT ALSO INDUCE SUCH A RESPONSE.  TO MINIMIZE 
THIS POSSIBLE HAZARD, WHEELOCK STRONGLY RECOMMENDS THAT THE NUMBER OF STROBES INSTALLED WITHIN 
A SINGLE ROOM, HALLWAY OR OTHER FIELD OF VISION NOT EXCEED THE PARAMETERS PRESCRIBED BY APPLICABLE 
LAWS, STANDARDS, REGULATIONS AND GUIDELINES.  WHEELOCK ALSO STRONGLY RECOMMENDS THAT THE 
INTENSITY AND FLASH RATES OF SUCH STROBES NOT EXCEED THOSE LEVELS ESTABLISHED BY APPLICABLE LAWS, 
STANDARDS, REGULATIONS AND GUIDELINES. 

 

ANY MATERIAL EXTRAPOLATED FROM THIS DOCUMENT OR FROM WHEELOCK MANUALS OR OTHER DOCUMENTS 
DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS, OR FOR ANY OTHER USE, 
INCLUDING DESCRIPTION OF THE PRODUCT'S APPLICATION, OPERATION, INSTALLATION AND TESTING IS USED AT 
THE SOLE RISK OF THE USER AND WHEELOCK WILL NOT HAVE ANY LIABILITY FOR SUCH USE. 

 

The Multitone Strobe products and these instructions are copyrighted by Wheelock and contain proprietary, confidential and trade 
secrets of Wheelock.  No part of the Multitone Strobe products and these instructions may be photocopied, printed or reproduced in 
any form or modified, adapted, changed or enhanced, or converted to another programming language, or used to create updated, 
related or derivative works, without the prior written consent of Wheelock.  No part of the Multitone Strobe shall be decompiled, 
disassembled or reverse engineered. 

 

NOTE:

  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 

FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in residential installation.  This 
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a 
particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
1) Reorient or relocate the receiving antenna,  2) Increase the separation between the equipment and receiver,  3) Connect the 
equipment into an outlet on a circuit different from that to which the receiver is connected, and  4) Consult the dealer or an 
experienced radio/TV technician for help. 

 

IMPORTANT:  READ SEPARATE "GENERAL INFORMATION" SHEET FOR INFORMATION ON THE PLACEMENT, 
LIMITATIONS, INSTALLATION, FINAL CHECKOUT, AND PERIODIC TESTING OF NOTIFICATION APPLIANCES. 

P83160 C 

Sheet 5 of 6 

Содержание MT4-115-WH







Отзывы: