Wexiodisk WD-90GR FLEX, Инструкция по установке и эксплуатации

Страница: 50 / 68

WD-90GR FLEX / HC Rev. 4.0 (202206)
Operating instructions
46
Machines without a drain pump
• N.B.! Before changing the water, you must run programme P4. Use a cas-
sette containing no items for washing.
• Press the 0/1 button (6) to switch off the power. Keep the door shut and
press the buttons (17) on the side of the machine.
• Lower the door in parallel with the front panel.
• Take out the rotating table (16), the filter (14) and the cover plates (15).
Rinse these items in water.
• Turn the level pipe (21) a quarter of a turn to empty the tank.
• If necessary, rinse the wash tank and the granules with water.
• Turn the level pipe (21) back a quarter of a turn until the rubber sleeve (22)
seals with the bottom plate.
• Replace the cover plates, filter and rotating table.
• Press 0/1 (6) and close the door.
• The machine will now fill with clean water.
When the tank is full and the correct operating temperature has been reached,
the machine is ready for use again.
Machines with a drain pump
• N.B.! Before changing the water, you must run programme P4. Use a cas-
sette containing no items for washing.
• Press the 0/1 button (6) to switch off the power.
• Take out the rotating table (16), the filter (14), the cover plates (15) and the
level pipe (21). Rinse these items in water.
• Press the program button P1 to start the draining.
• If necessary, rinse the wash tank and the granules with water.
• Replace the level pipe, filter, cover plates and rotating table.
• Press 0/1 (6) and close the door.
• The machine will now fill with clean water.
When the tank is full and the correct operating temperature has been reached,
the machine is ready for use again.