Wetelux 84 26 17, Инструкция по эксплуатации

Страница: 10 / 13

9
Using
This bicycle LED set is a handy illumination accessory for your
bicycle. Due to the LED technology it is energy efficient and
therefore battery power and environment friendly. The bright
light offers powerful illumination on your route. Both lamps are
splash-proof and shock resistant.
Inserting the Batteries (Headlight)
1. Open the battery compartment by turning counter clockwise
and insert 4 batteries of the type LR03 (AAA), observing
right polarity. You will find the polarity s (plus) and
– (minus) besides the battery compartments.
2. Close the battery compartment. The lid fits only in one
position on the housing. The lid is equipped with bayonet
locks. To close the lid, insert both bayonet locks in the
adequate opening and turn the lid in clockwise direction.
3. To switch on the front light, press the ON/OFF button once.
To switch off, press the ON/OFF button again.
If the red low battery indicator LED lights up, replace the
batteries.
Attaching and Using the Headlight
1. Attach the fastener on the handlebar. Depending on the
diameter of the handlebar, use the rubber pads.
2. Tighten the screw until the fastener is fixed securely and
cannot be moved.
3. Slide the headlight at its front-end on the fastener as far as
it will go. To remove the headlight, press the lever and pull
out the front light from the fastener.
4. To remove the fastener loosen the screw and push down
the fastener from the handlebar.