Wetelux 84 26 17, Инструкция по эксплуатации, Страница: 11 / 13

10
Using
Inserting the batteries (Rear Light)
1. Open the battery compartment by pressing the PRESS
button and pull out the lid in direction of the arrow.
2. Insert 2 batteries of the type LR03 (AAA), observing right
polarity. The polarity symbols are shown in the battery
compartment.
3. Close the battery compartment by applying the lid on it and
push the lid contrary to the imprinted arrow until the lid
locks audibly and visibly.
4. To switch on the rear light, press the ON/OFF button once.
To switch off, press the ON/OFF button again.
If the green low battery indicator LED does not light up,
replace the batteries. The complete rear light must be
replaced after one of the red light diode expired.
Attaching and Using the Rear Light
1. Attach the fastener on the seat post. Depending on the
diameter of the seat post use the rubber pads.
2. Make sure that the lower edge of the rear light is parallel to
the road and in the centre of the bicycle.
3. Slide the rear light in direction of the arrow on the fastener
and lightly lift up the lever. Slide the rear light as far as it will
go into the fastener until the lever hooks in the pin.
4. To remove the rear light, lift up the lever and pull out the
rear light from the fastener.