195114000 Rev. 220911-0
10-22
Il presente documento non può essere riprodotto né portato a conoscenza di terzi senza autorizzazione della ditta Omvl S.p.a.
This document may not be reproduced or made known to any third party without permission of the company Omvl S.p.a.
195114000 Rev. 220911-0
11-22
Il presente documento non può essere riprodotto né portato a conoscenza di terzi senza autorizzazione della ditta Omvl S.p.a.
This document may not be reproduced or made known to any third party without permission of the company Omvl S.p.a.
Where to install the control unit:
- FAR
from any
WATER LEAKAGE
- FAR
from
EXCESSIVE HEAT SOURCES
(such as exhaust manifolds).
- FAR
from
HIGH-VOLTAGE CABLES.
Create efficient electrical connections without using any “POWER TAPS”.
Properly insulated soldering is the most effective type of electrical connection.
Advise the customer that if the GAS system fuse burns, the connections of the
devices to which it is connected will be restored. It is strongly recommended
not to replace the fuse with another one with a higher amperage rating since
it may cause irreparable damage.
Do not open the Control Unit box for any reason, especially when the engine is running
or the key is in the ignition, to avoid irreparable damage.
OMVL will not be held responsible for damage to property or injuries to persons
if unauthorised personnel tamper with its devices; such tampering will also
invalidate the WARRANTY.
CORRECT
INSTALLATION
INCORRECT
INSTALLATION
INCORRECT
INSTALLATION
How to install the Control Unit
NO
TUBE MAy FILL WITH
“CONTAMINATED”
WATER
THAT WILL CORRODE
THE SENSOR
Regulator
compensation
Pressure sensor
(MAP)
SENSOR BELOW
MANIFOLD
Pressure
Pressure
V
Pressure
V
OK
Pressure sensor
(MAP)
Regulator
compensation
SENSOR ABOVE
MANIFOLD
Pressure
I
nt
ak
e
m
a
n
if
o
ld
I
nt
ak
e
m
a
n
if
o
ld
GENERAL INFORMATION
ENGLISH
MAP POSITIONING DIAGRAM
ENGLISH
