WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
4/06/10
TECH-385Q/D.W.O. 19105
Page 2 of 5
1.
Warnings
•
Never remove enclosure cover or make/break electrical connections
with power connected to the unit.
•
Perform all wiring in accordance with site and local codes and the
National Electric Code ANSI-NFPA-70 (US) or the Canadian Electric
Code Part I (Canada) for the appropriate area classifications.
•
Confirm that the AccuTrak model being installed is approved for the
hazardous area (see unit ID label).
•
Confirm that supply power to switches is within rated specifications
listed on the unit identification label.
•
Protect the unit from exposure to aggressive substances or
atmospheres to ensure that hazard rating is not compromised.
2.
Installation
2.1.
Mounting Instructions
Required Tools: Open-end wrenches or adjustable wrench to fit all sizes of
hex head bolts in the mounting kit.
1.
Obtain a mounting kit suited for the actuator/valve, commonly available
through a local Westlock Controls distributor.
2.
Attach the mounting bracket and coupler (if required) to the unit
housing with the hardware provided.
3.
Attach the unit and mounting system to the actuator.
4.
If mounting kit includes coupler, ensure proper axial alignment
between unit shaft, coupler and actuator shaft. Failure to ensure this
alignment could result in long-term stress-related failure of unit shaft in
high cycle or high torque applications.
NON-NAMUR
ACTUATOR
NAMUR
ACTUATOR
MOUNTING KIT
COUPLER
