Westinghouse WQE6870, Руководство пользователя

Страница: 8 / 28

WARNING
Never connect the appliance to a hot water
supply.
Do not use with water that is microbiologically
unsafe or with water of unknown quality without
adequate disinfection.
To Connect Water Supply Line to Ice Maker Inlet
Valve
Installation kit supplied with Refrigerator:
A - Adapter ½ to ¼ inch to connect the water
supply outlet to the water supply line.
B - Water supply line ¼ inch with 3 meters in
length.
C - ¼ inch connector to connect the water
supply line to the refrigerator tube.
1. Disconnect the refrigerator from the power
source.
2. Attach the adapter (item A above) to the water
line, connect the water supply line (item B) to
the adapter (item A) while holding the other
end of the water supply line in a bucket or sink
Turn on the water supply to eliminate air and
clean the water supply line.
Turn off the water supply.
3. Remove the plastic protector from the
refrigerator tube and connect the water supply
line (item B) to the refrigerator tube using the
connector (item C) as shown in fig.
Make sure the tubes are inserted completely
into the connections.
4. Wrap excess water supply line behind
refrigerator so that it does not vibrate with
refrigerator operation.
Do not twist the pipe.
5. Turn on the water supply, check that there are
no leaks in the connections.
6. Reconnect the refrigerator to the power source.
7. The Ice Maker is factory-switched, within 24
hours your refrigerator will have produced ice,
discard the first production.
Note: Expect the first ice harvest within
first 24 hours of unit operation. To prevent
any issues concerning ice production,
please ensure that all water lines are
primed. See “Priming the water supply
system “in the “AUTOMATIC ICE & WATER
DISPENSER” section.
Figure 2
IMPORTANT
A
B
C
Figure 1
Adapter to connect
the water supply
outlet to the water
supply line.
Connector to
connect the water
supply line to the
refrigerator tube
Your refrigerator’s water supply system
includes several tubing lines, a water filter, and a
water valve. To ensure that your water
dispenser works properly, this system
must be completely filled with water when
your refrigerator is first connected to the
household water supply line.
Water Filter
The water filter should not be used on water
that is micro biologically unsafe or with water
of unknown quality. The service life of the filter
may be reduced in water supplies that contain
an excess of particles or other impurities.
Reduced flow rate is an indication that a new
filter is required. Failure to replace the filter
when required can affect the function of the
ice maker. Service calls caused by a failure to
replace the filter are not covered by warranty.
Replacement water filters are available from
Electrolux Home Products Spare Parts Centres
and can be posted to you for your convenience
(refer to spare parts contact numbers on the
warranty page).
8
plastic
cap
Remove
plastic cap
from water
inlet fitting
Water Inlet
Fitting
¼ inch
plastic tube
to water
valve