16 | Westinghouse Outdoor Power Equipment
CARE AND MAINTENANCE
CARE AND MAINTENANCE
ELECTRIC SHOCK HAZARDS
Before cleaning the air conditioner, turn off the unit
and disconnect power.
Do not spray or splash water or other liquids onto
the unit; this may cause electric shock.
Do not use corrosive detergents to clean the
appliance; this may damage the plastic components,
and cause electric shock.
Do not use volatile liquids (such as paint thinner or
gas) to clean the air conditioner. This may damage
the appearance of air conditioner.
CLEAN OUTER CASE AND GRILLE
If there’s dust on the surface of outer case, use a soft towel
to wipe it. If the outer case is very dirty or greasy, use a soft
cloth dampened with mild detergent and water. Do NOT
allow water to drip in to the unit.
Use cleaner or soft brush to clean the grille.
CLEANING THE FILTER
1.
Press the clasp as shown below, and then remove the
filter.
Filter 2
Part no: 111001060166
Filter 1
Part no: 111001060165
2.
Use cleaner or water to clean the filter. If the filter is very
dirty (such as grease), use warm water 104°F(40°C)
mixed with mild detergent to clean it and then put it in a
shady place to dry it.
3.
After the filter is cleaned and dried, reinstall it.
CLEAN EXHAUST DUCT
1.
Remove the exhaust duct from air conditioner, clean
and dry it, and then reinstall it.
EMPTY WATER FROM CHASSIS
If continuous discharge isn’t possible, the unit must be
periodically emptied.
During Cool mode or Auto mode, it is not recommended to
remove the collected water. Leaving the water will improve
performance and save energy.
During Dry mode, it is recommended to use the middle
hole to drain outlet.
1.
When the chassis is full of water, the unit will buzz 8
times and the display will show “H8.”
2.
Move the unit to a suitable place for discharging water.
Note:
Do not tilt the unit--keep it vertical while moving.
3.
Remove the rubber plug from the drainage port and
allow the water to drain.
4.
Replace the rubber plug on the drainage port.
5.
After water has been emptied and the compressor
has been stopped for 3 minutes, the unit will resume
operation.
drainage port
CHECKING BEFORE USE-SEASON
• Check whether air inlets and air outlets are blocked.
• Check whether plug and socket are in good condition.
•
Check whether filter is clean.
• Check whether batteries are installed in remote control.
• Ensure that exhaust connector, window bracket and
exhaust duct are installed tightly.
• Check whether exhaust duct is damaged.