8
CLEANING & CARE
1.
Medium and low heat settings will yield the best results for most types of cooking.
Heating the skillet gradually will ensure even heat distribution. Do not use your
skillet on maximum temp settings as this will shorten the life of the non-stick
coating.
2. Do not allow your skillet to boil dry as this may cause damage to the non-stick
surface.
3. The skillet is suitable for use with wood, nylon and plastic utensils. Do not use
steel utensils as they may scratch the non-stick surface. Scratching of the non-
stick surface is not covered by warranty.
CLEANING
1.
Allow the skillet to cool thoroughly after using. Exposing your skillet to water
whilst hot may cause warping and/or damage.
2.
Once cooled, the skillet with water and allowing it to soak will assist in the
removal of tough baked on particles.
3. When washing, non-abrasive cloths and plastic bristle kitchen brushes may be
used to remove stubborn food particles from your skillet. Do not use abrasive
cloths and cleaning materials as they may damage the non-stick surface.
4. The skillet and lid are fully immersible and can be washed in warm soapy
water using a mild household detergent and a soft washing sponge. For added
convenience, they can also be cleaned in the dishwasher.
5. Ensure both probe and skillet are completely dry before inserting probe into
skillet for use.
6.
Should your skillet require cleaning of stubborn stains and build-up, the following
method is recommended:
***Combine: 2 tablespoons bicarbonate of soda and 2 teaspoons water***
i).
Pre-heat the skillet for approximately 1-1.5 minutes on setting 150 degrees
celcius.
ii). Turn the power OFF at the power outlet, remove the plug from the power
outlet and remove probe from the skillet
iii). Brush the above paste solution onto the non-stick surface and allow to stand
for one hour.
iv). Wash the skillet in warm soapy water using a mild household cleaner and a
soft washing sponge.
7.
Ensure skillet is dried thoroughly and stored in a dry place away from steam and
humidity where possible.
DANGER:
Do not under any circumstances immerse the power cord, mains plug or
temperature control probe in water or any other liquid.
WARNING:
Do not place the temperature control probe in the dishwasher.