4 of 4
ISSUED: 01-18-05 SHEET #: 201-9326-1
Visit the Westinghouse Web Site at www.westinghousedigital.com
For customer service call
1-866-287-5555
.
SCREWS
SPACERS
BB
fig 2.2
CC
O
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.
Place adapter brackets (
BB, CC
) on back of screen, align to holes, and center on back of screen as shown in figure
2.1. Refer to step 1 to determine the proper fasteners to use. Attach the adapter brackets to the back of the screen
using the appropriate combination of screws, multi-washers (
O
), and spacers as shown in figure 2.2. Verify that all
holes are properly aligned, and then tighten screws using a phillips screwdriver.
2
CC
CENTER BRACKETS
VERTICALLY ON
BACK OF SCREEN
X
X
fig 2.1
BB
Note:
"X" dimensions should be equal.
Notes:
• Latches on adapter brackets must face
outward for proper installation as shown in
figure 2.2.
• The number of fasteners used will vary,
depending upon the type of screen.
• Spacers may not be used, depending upon
the type of screen.
• Tighten screws so adapter brackets are firmly
attached. Do not tighten with excessive force.
Overtightening can cause stress damage to
screws, greatly reducing their holding power and
possibly causing screw heads to become
detached.
Tighten to 40 in. • lb (4.5 N.M.)
maximum torque.
• If spacers are used, they must be centered and
squared over bracket slot for safe installation.
WARNING
Installing Adapter Brackets
LATCH
and Westinghouse are trademarks of Westinghouse Electric Corporation and are used under license.