Westgate DV62, Техническое руководство

Страница: 32 / 54

i
nStallation
S
et
-u
P
L
og
b
uRneR
/ e
mbeR
b
eD
i
nstaLLation
:
1. In the bottom rear of the firebox there are two (2)
gas orifices in a housing that facilitate the air shutter
mechanisms and the Burner Mounting Brackets are
above them (See Figure 53). There are two (2) mixing
tubes underneath the back of the burner (see Figure
54). Lift the burner into the firebox with the back of the
burner tilted downward. Keep the burner high enough
at the front to clear the pilot assembly. Line up the
mixing tubes with the holes in the burner mounting
brackets and slowly lower the front of the burner over
the pilot assembly (see Figure 55).
2. Pull the burner forward up to the angular brackets near
the front of the firebox (see Figure 56).
IMPORTANT: If the burner is not far enough back
to lower the burner behind these brackets, then the
mixing tubes are not engaged in the air shutter. Failing
to ensure the mixing tubes are located in the mixing
tube support brackets may cause serious performance
and or safety issues.
3. Install the burner accent pieces as shown in Figure
57. There are a left, a right and a front ceramic trim.
On each side of the burner and on the inside of each
burner side accent pieces there is a slot, which should
be aligned in order to position the log grate correctly
(see Figure 58).
4. The firebox grate has two (2) tabs that run below the feet
of the grate (see Figure 59), place the grate over the burner top and carefully inserting the grate tabs into
the slots on the burner (see Figure 60). Once the grate is installed correctly, the burner, grate, and side
burner accents will be all locked together.
Figure 53: Burner Mounting Brackets.
Figure 55: Log Burner Over Pilot Assembly. Figure 56: Log Burner in Place.
Figure 54: Burner Mixing Tubes
32