Westfalia Laser 2000 10 69 48, Инструкция по эксплуатации

Страница: 28 / 35

23
Cleaning the Accessory
Cleaning the Turbo Brush
1. Disassemble the turbo brush in order to clean it thoroughly.
2. First grasp the catches at the left and right side of the housing and gently and
very carefully pull out the catches. Then use your finger to press the brushing
roller in the opposite direction. Now the turbo brush is disassembled and the
housing can be removed.
3. Remove long hair or other large dirt particles from the brushing roller.
4. Reassemble the turbo brush and make sure the catches engage into place in
the holding pins of the housing.
Cleaning the Drive Belt of the big
Brushing Roller
It is important to remove long hair or other large dirt
particles from the drive belt of the big brushing roller
at regular intervals.
Replacing the Drive Belt of the Turbo
Brush
1. If the drive belt has to be replaced, carefully lift
up the brushing roller from the notches and
replace the drive belt.
2. Insert the new drive belt as shown.
The article number of the replacement drive belt
is 91 57 140.