15
Operation
Cleaning the Filter during Operation
When the suction power deteriorates the filter cab be shaken out during
use by a device integrated into the appliance. Press the filter cleaning
button (3) while the appliance is running. This function lengthens the
service life of the filter.
Emptying the Ash Tank and Cleaning the Filter
Clean the filter after each use. Empty the ash tank when the full indicator
next to the ON/OFF button (2) shows red or when the appliance loses its
suction power. Please note that cold ashes become incrusted on the filter
during vacuuming. This will block the filter and the motor will not be
properly aired.
1. First switch off the ash vacuum and pull the power cord before opening
the ash tank.
2. Tap the filter carefully to remove the ash from the surface. Preferably
clean the filter outdoors by using a hand broom, compressed air or
similar.
Replacing the Filter
The filter is reusable and should be cleaned after each use. Be careful
when cleaning the filter; make sure not to damage it. Replace a damaged
and completely worn filter with one of the same type.
You can order a replacement filter under the article no. 88 91 59.
Cleaning the Ash Vacuum
Switch off the ash vacuum and unplug from power mains before
cleaning the appliance.
Clean the housing of the ash vacuum only with a dry of lightly mois-
tened cloth. Do not use chemicals or abrasives, in order not do damage
the surfaces. Do not immerse the lid with the motor into water.
Storing
Store the ash vacuum in a dry and cool place. Do not store the appli-
ance close to heat sources such as heaters.
Do not expose the ash vacuum to direct sunlight for an extended time.
Extreme heat will damage the appliance.
