9
Installation and commissioning
Assemble the instantaneous water heater according to figure 3 or 4. It can be
assembled on threaded or smooth pipes.
For mounting on a thread, combine the enclosed thread adapters (a) in a
suitable manner, e.g. B. to mount on the hose thread or on the aerator thread
of your tap. Always use the enclosed sealing rings (b) between the adapters.
To mount on a smooth pipe, use the enclosed adapter with hose clamp.
Always use the enclosed sealing rings (b) between the adapters
The instantaneous water heater must always be connected to the water supply
first. Only then connect it to the power supply. To do this, always use a properly
grounded socket protected by an RCD. Cable ties (c) are included to secure the
cable.
Operation
The temperature can be regulated using the rotary control on the right side of
the device. The water temperature is displayed. Please note that at the end of
the warm setting, the water flow is highest, but the temperature is lowest.
If the device does not respond or displays an abnormal display, unplug it for a
few minutes and then turn it on again. If the problem persists, press the reset
button located under the temperature control wheel. See also Figure 2.
Technical Data
Power supply:
220 - 240 V~ 50/60 Hz
Water temperature:
up to 60° C
Rated power:
3000 - 3600 Watts
Water Flow:
1.4-6 l / min
Operating pressure:
0.4 - 4 bar
Degree of protection:
IPX4
Material:
Plastic, metal-coated
Enclosed adapters:
1/2", 3/4", universal adapter for smooth pipes, hose
clamp
Power Cord:
1.4 m
OPERATION
