13
Operation
To clamp the sander to the workbench in the desired position, simply open the
threaded clamp screw (10) , insert the top of the clamp into the clamping cavity
(A or B) and tighten the clamp screw until the sander is securely locked onto
the workbench.
Removing the Sanding Table Assembly
The sanding table assembly must be
removed before installing or replacing
sandpaper on the sanding plate.
Warning:
Remove the plug from the power
source before removing the sanding table
assembly.
1. Insert the included 5 mm hex key (A) into
the sanding table assembly mounting
screw (6).
2. Turn the mounting screw counter clockwise until both the screw and the
washer can be removed.
3. Slide the sanding table assembly (B) outward away from the sanding plate.
Note:
Once the sanding table has been removed, the sandpaper can be
removed or installed as shown in below.
4. To reinstall the sanding table assembly, place it against the bottom of the
motor housing (C) and slide it toward the sanding plate.
Note:
Make sure
the positioning tabs are fully inserted into the matching slots in the motor
housing.
5. Reinstall the sanding table attachment screw and washer and tighten it
using the 5 mm hex key.
Note:
Do not over tighten the screw. You may
damage the motor housing.
Removing and Installing Sandpaper
Warning:
Remove the plug from the power
source before removing or installing
sandpaper.
6. Remove the sanding table assembly as
noted above.
7. Peel the old sandpaper (A) from the
disc (1).
8. Peel the protective paper from the new
sandpaper.
A
1
A
C
B
6
Содержание 90 00 83
Страница 3: ...III Übersicht Overview 1 2 5 6 7 8 9 3 4 10 11 ...
Страница 23: ...19 Notizen Notes ...
Страница 24: ...20 Notizen Notes ...
