Western CP600, Руководство по эксплуатации

Страница: 17 / 134

CP600 Pivot Operation Manual
POM-EN-Dec
ember 20
18
17
4. Each input and output shaft should be checked for excessive endplay after each crop cycle.
Disconnecting the driveline coupler & tapping the input shaft on both sides with a dead blow
hammer or mallet does this. If play is present, input shims should be installed to eliminate
bearing backlash.
5. All cover and end cap bolts should be torqued to 28-31 ft.-lbs (38-42 N-m).
6. All wheel lug nuts should be torqued to 115-120 ft.-lbs (156-162 N-m).
7. Remove drain plug located at bottom of gearbox and completely drain gearbox. If oil is con
taminated or emulsified, flush gearbox with a cup of specified oil and let drain completely.
8. Replace drain plug and refill gearbox through top fill hole to the proper operating level
(top of worm gear) as shown below. After one or two hours the oil should be re-checked. Air
may be trapped in the gearbox during initial filling. Top off with oil as needed.
Figure 1-13.
Section 1-13
Operation, Safety & Maintenance
Power Drivetrain Maintenance