Western CP600, Руководство по эксплуатации

Страница: 21 / 134

CP600 Pivot Operation Manual
POM-EN-Dec
ember 20
18
21
Worm Gear Center Drive Maintenance
A. The worm gear center drive must be serviced as follows after each crop cycle
(minimum of once per year):
1. Inspect input and output shaft seals for leakage. Should either the input or output shaft
seals show excessive leakage, the seals should be replaced. All replaced seals must be
installed with generous amounts of #2 Barium/Lithium based grease or equivalent quality
#2 water resistant grease.
2. External dust exclusion seals should be used to keep dirt and water out of internal seal lo
cations. If the external seals are damaged or worn, replace with new seals.
3. The flange drain hole located under the motor mount flange must be clear. Clear the hole
with a 12 gauge wire, nail or punch by rotating the tool in the hole to loosen and remove
dirt.
4. All 5/16-18 flange bolts and end cap bolts should be torqued to 13-15 ft-lbs (18-0N-m).
5. To drain gearbox, remove drain plug located at bottom of worm gear and bottom of side
case cover. If oil is contaminated or emulsified, flush gearbox with a cup of specified oil and
let drain completely.
6. Replace drain plug and refill gearbox through top side fill hole to proper operating level (mid
worm gear). Refer to gearbox oil specification. After one or two hours the oil should be re-
checked. Air may be trapped in the gearbox during initial filling. Top off with oil as needed.
Section 1-17
Operation, Safety & Maintenance
Power Drivetrain Maintenance