Lit. No. 27554, Rev. 08
9
August 1 , 2006
27550
1/4"
Locknut
1/4" x 2-3/4"
Cap Screw
1/4" x 90º
Swivel Elbows
Filler Breather Plug
1/4" Straight
Fitting
8"
Scrape Lock
Hose
36" Driver-Side
Angle Ram Hose
To Driver-Side
Angle Ram
To Passenger-Side
Angle Ram
36" Passenger-Side
Angle Ram Hose
22" Lift Ram Hose
Mounting Hydraulic Unit
1. Attach the hydraulic unit to the plow gear using two
1/4" x 2-3/4" cap screws and two 1/4" locknuts.
2. Remove the plugs from the angle ports, lift port, and
reservoir. Screw 90° elbows into the angle and lift
ports. Screw a straight fitting into the bottom of the
reservoir. Screw the filler breather plug into the top
of the reservoir.
3. Looking at the front of the vehicle, orient the swivel
elbows in the angle and lift ram ports as shown,
then tighten these elbows and the straight fitting
using the procedure on the previous page.
4. Route hydraulic hoses as shown. Take care to align
the hoses so there are no twists or sharp bends
and so they will not be pinched or pulled by moving
parts.
5. Tighten hoses using the procedure on the previous
page.
