Lit. No. 27554, Rev. 08
11
August 1 , 2006
27550
HEADLAMP INSTALLATION
1. Slide a headlamp swivel onto the screw on the
underside of the driver-side headlamp assembly.
The park/turn lamp should be to the outside of the
plow gear.
2. Locate a 1/2" flat washer from the plow gear kit.
Slide the washer into the end of the plow gear tube
on the driver side. Fit the screw from the headlamp
through the hole in the top of the plow gear and
through the flat washer. Secure with a lock washer
and nut from the headlamp kit.
WARNING
Your snowplow must be equipped with
headlamps and directional lights.
NOTICE TO INSTALLER
Plow Lights must be aimed while plow
is in raised position. Aim plow lights
according to SAE J599 Lighting Inspec-
tion Code. See installation instructions
for additional information.
PASSENGER SIDE
DRIVER SIDE
Black/Orange Ground Wire
(Connect to NEGATIVE (–) motor terminal.)
Headlamp Swivel
(Found in headlamp kit.)
1/2" Flat Washer
(Found in plow gear kit.)
Lock Washer and Nut
(Found in headlamp kit.)
Park/turn lamp should
be on outside.
Read, follow, and
remove label (if present).
3. Repeat steps 1 and 2 on the passenger side.
4. Route the black/orange ground wire from the
snowplow lighting harness to the NEGATIVE (–)
motor terminal.
5. Read, follow, and remove the headlamp label if one
is present.
