Lit. No. 94430/94431, Rev. 09
11
October 1, 2018
FIXED MOUNT SPREADER
NOTE: The spreader shall be installed according
to instructions supplied. Your local outlet is
trained to provide this service and service your
spreader with factory original parts.
CAUTION
During removal or mounting, securely grip
spreader to avoid dropping.
MOUNTING THE SPREADER
1. Install the left and right top brackets to the truck
bed rail with two 1/2" cap screws, four 1/2"
fl
at
washers, and two 1/2" locknuts per side. Secure
the small mounting
fl
ange of each top bracket to
the bed rail using two 5/16" cap screws, two 5/16"
fl
at washers, and two 5/16" locknuts per side.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
2. Place the spreader on the bumper and line up
the holes in the bottom feet with the holes in the
bumper.
3. Attach the spreader to the top brackets using two
3/8" cap screws and two 3/8" locknuts per side.
4. Attach the spreader to the bumper of the truck
using one 3/8" cap screw, one 3/8"
fl
at washer,
and one 3/8" locknut per side.
5. Plug the spreader harness into the vehicle
harness.
