Western Shelter Systems WS-VC-CBTA, Быстрый старт

Страница: 14 / 15

14
G. TIPS, CARE, AND REPAIR
Ø Western Shelter Systems provides
protective bags for shipping and storage. Do
not drag these bags on the ground.
Ø Replacing the components in the proper
bags or aluminum cases ensures all parts
are accounted for and ready for the next
deployment.
Ø Cleaning and drying of your shelter system
will extend the life of the shelter and
eliminate health issues associated with
particulate buildup. Maintenance is best
performed when the shelter is being taken
down. If the shelter must be packed when
wet and/or dusty, It is VERY important that
the shelter is cleaned and dried as soon as
possible.
Ø
Utilize the following steps to ensure that
proper care and maintenance has been
performed.
1. Vinyl Panels (roof, walls, and floor)
q
Clean and fold on a clean surface, such
as the shelter floor. Sweep off loose
debris. Remove debris from hook and loop
fasteners using a rigid brush.
q
Clean with a mild solution such as Simple
Green™, Tilex™, or 10% bleach water
solution.
q Do not saturate the fabric, especially the
hook and loop fastener, which tends to
retain water even after prolonged drying
times.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
2 Insulation Panels (roof & walls)
q Clean and fold on a clean surface, such
as the shelter floor. Sweep off loose
debris. Remove debris from hook and loop
fasteners using a rigid brush.
q
Clean with a mild solution such as Simple
Green™, Tilex™, or 10% bleach water
solution.
q Do not saturate the fabric, especially the
hook and loop fastener, which tends to
retain water even after prolonged drying
times.
q
Do not spray cleaner directly on fabric as it
could soak into the air bubbles on the fabric,
leading to mold and mildew. Spray cleaner
on shop towels and wipe to clean.
q
Never pressure wash the insulation panels.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
Ø Note: Stains can occur on the white
insulation fabric. These stains, once
cleaned, are purely cosmetic and do not
indicate product failure or health risks.
3. Main Frame, Eave & Base Bars
q Brush off loose debris. Clean dirt and debris
out of the ends of the bars and legs. Wipe
down with a mild solution such as Simple
Green™, Tilex™ or a 10% bleach water
solution.
q
Dry thoroughly using towels, leaf blowers or
sunlight.
4. Hinge Points & Pull Pins
q Keep moving parts free of debris and dust.
Disassemble and clean if binding occurs.
q
Do not use liquid lubricant on moving parts,
as this will cause fouling.