18
6179-2201
&V1 – Display Last Connection Statistics
Displays the last connection statistics in the following format (shown with typical results):
TERMINATION REASON.......... LOCAL REQUEST
LAST TX rate................ 26 400 BIT/S
HIGHEST TX rate............. 26 400 BIT/S
LAST RX rate................ 46 667 BIT/S
HIGHEST RX rate............. 46 667 BIT/S
PROTOCOL.................... LAPM
COMPRESSION................. V42Bis
Line QUALITY................ 033
Rx LEVEL.................... 015
Highest Rx State............ 67
Highest TX State............ 67
EQM Sum..................... 00C2
RBS Pattern................. FF
Rate Drop................... FF
Digital Pad................. None
Local Rtrn Count............ 00
Remote Rtrn Count........... 00
Flex 9481814347C4
RBS Pattern: Shows the number of least significant bits robbed per 6 bytes.
Digital Pad: Shows if a pad was encountered and if so, what was the digital loss.
Flex: Shows V.8bis information as follows:
First byte: Octect 13 (second byte of manufacturer id, 94 = K56flex)
Second byte: Octect 14 (Licensee code: 81 = Rockwell)
Third byte: Octect 15 (manufacturer's product capabilities)
Fourth byte: Octet 16 (K56flex version number)
Fifth byte: Octet 17 (Rockwell pump code version number)
Sixth byte: Octet 18 (x-law and controller version number)
Bit 6 Forced/Not forced A-Law/µ-Law
0 = Forced A-Law/µ-Law
1 = Not forced A-Law/µ-Law
Bit 5 Select A-Law or µ-Law
0 = Select A-Law
1 = Select µ-Law
Bit 4:0 Controller version
Wn – Connect Message Control
This command controls the format of CONNECT messages. The parameter value, if valid,
is written to S31 bits 2 and 3.
W0 Upon connection, the modem reports only the DTE speed (e.g., CONNECT
19 200). Subsequent responses are disabled.
W1 Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed, respectively. Subsequent responses are disabled. (
Default
)
W2 Upon connection, the modem reports the DCE speed (e.g., CONNECT 14 400).
Subsequent responses are disabled.
