Position
Device mode A
Device mode B
1
+DC
2
+DC
3
-DC
4
-DC
5
-DC
6
-DC
7
+DC
8
+DC
Table 8. Ethernet PoE connection on X2 (LV-model only)
NOTE
PoE is supported on X2 for the LV product variant only.
NOTE
If the Ethernet function is not used, the protective dust cap which is part
of the delivery must be closed to protect the interface from water or dust
ingress.
3.4.4. Antenna Ports
The antenna connectors are identified on the product with A1 to A6. QMA industrial
standard connector is used.
A4 and A5 are used for LTE communication. Both antennas ports must be used and
connected to external LTE antennas.
A1 to A3 are used for WLAN communication. At least A1 must be connected to an
external WLAN antenna. The antenna configuration is made through the software
interface.
A6 is used for the included GNSS receiver. The antenna port must be connected to an
external GNSS antenna.
NOTICE
Any unused antenna ports must be properly terminated with 50 Ohm,
otherwise the product might be damaged when power is applied to a non-
terminated antenna port.
18
Ibex-RT-630 Series
