WESTCRAFT.COM
Manufactured for/ Fabricado para: PL Sourcing, Inc.
P.O. Box 2778 Newport News, VA 23602
©2018 Ferguson Enterprises, Inc. 911181
Tighten blades to
blade brackets by
using blade screws
and washers.
Blade Screw
Washer
Blade Arm
Fig.1
Fig.2
Fig.3
Fig.4
NOTE: Before installing blade
brackets to the motor, please
remove the plastic inserts
.
Remove the motor screws and
washersfrom the motor
assembly.
Secure blade brackets to the motor
with washers and motor screws.
Motor Screw
Blade Arm
Blade
3. Light Kit Assembly
2. Blade Assembly
1. Canopy Assembly
Remove 3 screws from light kit fitter. Locate
BLACK
(or
BLUE
) and
WHITE
wires in the
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires
together.
Next, locate
WHITE
and
BLACK
wires in light
kit fitter labeled LIGHT.
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
)
wire from switch housing to
BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in light kit fitter with holes in switch
housing. Attach light kit fitter with screws that
were removed . Securely tighten all 3 screws with
Phillips screwdriver.
Install 1X6.5w LED bulb
Mount the glass shades on the light fixture by
unscrewing partway the thumb xcrews on the
glass holders, inserting the glass, then gently
tightening the thumb screws by hand evenly to
the glass. DO NOT OVER TIGHTEN. (Fig.4)
Important:
When replacing bulbs, please allow
bulb(s) and glass shade(s) to cool down before
touching them.
Fig.1
WIRING
1.
If using downrod
or angle style
mounting, connect
green wire
from downrod to
green wire on
mounting bracket.
2.
Strip 3/4 in. of
insulation from wire
ends. Twist stripped
ends together with
pliers. Snip ends.
Fig.2
Fig.3
3.
Screw wire nuts on in
a clockwise direction
Tape nuts and weires
together.
WARNING:
Be sure no bare wire or wire strands are visible after making connection. place green and white connections
on opposite side of from the black and blue (if applicable) connections.
Temporarily lift canopy to mounting bracket
to determine which screws align with slotted
holes in canopy and partially loosen these
screws. Remove the other two screws.
Raise canopy to mounting bracket, aligning
slotted holes in canopy with loosened screws
in mounting bracket. Twist canopy to lock.
Insert the other two screws in nonslotted
holes. Tighten all screws securely.
FINAL INSTALLATION
NOTE:
Before starting installation, disconnect the
power by turnning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to prevent
electric shock.
Restore power and your light kit is ready for
operation.
motor housing
Thumb
screws
switch
housing
fan
pull chain
extension
white
wire
black
(or blue)
wire
white wire black wire
molex connections
thumb
screws
light kit fitter
light
pull chain
extension
